After only 5 minutes of simple car seat cover installation steps
Installation Instructions:
1. Start the installation by removing both the front and rear headrests.
2. Place the cover of the front seats and connect the elastics below using the hooks provided with your cover.
3. Pay attention to the Airbag symbols, these must be located on the outside of the seat. Adjust the elastics at the bottom of the seat using metal hooks. Arrange the fabric well on the visible part of the cover to ensure that it is perfectly positioned.
4. Fit the rear bench seat cover. Whether your car has a full or split bench seat, the procedure does not change.
5. Raise the rear bench seat with a little force and adjust the elastics underneath using the metal hooks as indicated in figure 5. Raise the rear bench seat with a little force and adjust the elastics underneath using the metal hooks as indicated in figure 5
6. Attach the rear seat backrest part. In this case, if the seat is split, open the necessary zippers to adapt to your seat's shape.
7. Adjust the elastics on the back of the back using the metal hooks, as indicated in figure 7.
8. Place the covers of the 5 headrests, as indicated in figure 8.
9. Using a sharp tip scissor, very carefully, make the necessary holes in the cover to pass the headrests. Before carrying out this operation, make sure that all the backrest covers are straight and perfectly positioned.
10. Complete the installation by attaching the head restraints of all seats.
